United Kingdom
France
Germany
Netherlands
Sweden
USA
Italy
Spain
More From Contributor
1 Set MA/AR Chassis Modification Set Kit With FRP Parts For Tamiya
Mini 4WD RC Car Parts With Wheel
Description:Installation tool: tire puller tire loader screwdriver nut sleeve 1.mm hand drill (using a hand drill before drilling a large screw)Faucet assembly:The first step: remove the front and rear guides and rear brakes of the original carStep 2: Unpack the faucet kit1. Locate the faucet and compare the screw holes to the corresponding holes.2. Screws pass from bottom to top through the chassis and faucet3. Plus nut fixing4. Add the order on both sides, so that the gasket (protrusion head upwards) - bearing shaft - guide wheel copper tube - double guide wheel - bearing shaft - gasket (protrusion head down) - 6mm aluminum tube - wave head, Install in order, the same on the other sideMiddle wing installation:The first step is to open the middle wing bag, pass the screw through the
corresponding hole in the middle wing, fix it with a nut, then put it into the big nail, add the wave head.In the second step, the middle wing is fixed to the chassis, and the middle wing is mounted on the chassis from the bottom, and the small screws of the middle wing bag are taken out, and the middle wing is fixed to fix the chassis.The third step, after fixing the screw, the upper nutPhoenix tail installation:1. Remove the rear guide wheel and the bearing shaft, and use the tire puller to drive the bearing shaft into the guide wheel, from bottom to top: gasket, gasket, aluminum tube nut, aluminum tube, gasket, gasket, wave head2, The order of the installation of the phoenix tail is: screw - g
corresponding hole in the middle wing, fix it with a nut, then put it into the big nail, add the wave head.In the second step, the middle wing is fixed to the chassis, and the middle wing is mounted on the chassis from the bottom, and the small screws of the middle wing bag are taken out, and the middle wing is fixed to fix the chassis.The third step, after fixing the screw, the upper nutPhoenix tail installation:1. Remove the rear guide wheel and the bearing shaft, and use the tire puller to drive the bearing shaft into the guide wheel, from bottom to top: gasket, gasket, aluminum tube nut, aluminum tube, gasket, gasket, wave head2, The order of the installation of the phoenix tail is: screw - g
Product Description
Reviews/Comments
Add New
Vouchers
No voucher codes found.
Do you know a voucher code for this product or supplier? Add it to Insights for others to use.
Do you know a voucher code for this product or supplier? Add it to Insights for others to use.
Denmark