United Kingdom
France
Germany
Netherlands
Sweden
USA
Italy
Spain
More From Contributor
120W 110V 11X9cm Silicone Heating Plate For Car Engine Tank Heater
Description:1. High insulation performance, breakdown voltage up to 20~50KV/mm2. Silicone rubber heating plate is very convenient to install, it can be vulcanized by room temperature vulcanized rubber.3. Used for heating elements: The heating wire of nickel alloy is wound around the glass fiber, the heating power can reach 2.1W/cm2, and the heating is more uniform.4. Moisture-proof silicone rubber material provides longer heater life.5. Fast heating, uniform temperature, high thermal efficiency and good toughness6. Convenient, safe and waterproofFeature:Name: 120W 110V 11x9cm Silicone Heating Plate For Car Engine Tank HeaterModel: A79998Material: Alloy heating wire + silicone rubberColor: OrangeSize: 11x9cmVoltage: 110VPower: 120WNote:1. The use of this type of electric heating
device must be noted that its continuous use operating temperature should be less than 240 C, instantaneous does not exceed 300 C.2. The silicone electric heating device can work and be pressed, that is, it is pressed against the heated surface by the auxiliary pressing plate. The heat conduction is good, and the current density can reach 3W/cm2 when the working temperature does not Exceed 240 C.3. Under the installation condition of the paste, the working temperature is allowed to be less than 150 C.4. In the case of dry air in the air, the power density shall be less than 1 W/cm2 due to the temperature resistance of the material, in the case of non-continuous operation, the power density may reach 1.
device must be noted that its continuous use operating temperature should be less than 240 C, instantaneous does not exceed 300 C.2. The silicone electric heating device can work and be pressed, that is, it is pressed against the heated surface by the auxiliary pressing plate. The heat conduction is good, and the current density can reach 3W/cm2 when the working temperature does not Exceed 240 C.3. Under the installation condition of the paste, the working temperature is allowed to be less than 150 C.4. In the case of dry air in the air, the power density shall be less than 1 W/cm2 due to the temperature resistance of the material, in the case of non-continuous operation, the power density may reach 1.
Product Description
Reviews/Comments
Add New
Vouchers
No voucher codes found.
Do you know a voucher code for this product or supplier? Add it to Insights for others to use.
Do you know a voucher code for this product or supplier? Add it to Insights for others to use.
Denmark