Airbot TD215 215mm RC FPV Racing Drone PNP OMNIBUS F4 V6 TYPHOON 32 V2 35A ESC 600TVL Turbo EOS2 CAMSpecification: Airbot TD215 frame kit-Wheelbase: 215mm-Fuselage floor: 3MM*1-Arm: 4MM*4-Upper plate: 2MM*1-7075 aluminum column: 25MM*4 The Frame is only 70G ultra-light design. The aluminum columnis made from aviation 7075 aluminum super hardness. The fuselagearm adopts a narrow front & wide rear mechanicadesign tomake the steering in flight more precise. Airbot OMNIBUS F4 FC-STM32 F405 MCU, Runs Betaflightfirmware (supported from v 3.2)-MPU6000 Over SPI Bus in damping box.-30.5 x 30.5 mm Mounting holes-Supports Lipo direct plugin (3-6S)-Supports 5V 1A BEC output (Buck)-Supports 8V 1A BEC with LC filter output forthe camera and VTX (Buck)-STM32 controls OSD chip over SPI in DMAmode (Betaflight OSD)-More caps to reduce gyro power noise.STM32 F4 The Omnibus F4 V6 flight controller uses the MPU6000 over SPIfor the stable flight performance. Also onboard are a barometer & AB7456 OSD chip for the Beta Flight integrated OSD. Omnibus F4 V6 using same target as Omnibus Fire works supports 3-6s LIPO direct input, has 5x Hardware UARTs.TYPHOON 32 V2 ESC-32bit ESC with BLHELI32 firmware-Supports 3-6S lipo input-4PWM input-Voltage output (VBAT)-NO BEC-Supports oneshot / Multishot / Dshot PWM-Mounting holes 30.5x 30.5mm-Supports damped light-More caps to reduce power noise Mrs. Copper 2306 Motor-KV: 2700-Configu-ration:12N14P-Stator Diamter:23mm-Stator Length:6mm-Shaft Diameter:4mm (Hollo