Holy Bro 3DR Pixhawk Mini Autopilot Micro M8N GPS Built-in Compass PDB Board for RC Drone Introdution: The 3DR Pixhawk Mini autopilot is a next-generation evolution of the Pixhawk. It is about 1/3rd the size of the original Pixhawkand has more powerful processors & sensors. The Pixhawk Mini is based on the PX4 open-hardware project & has been optimized for the PX4 flight stack. Specification: Brand Name: Holy Bro Item Name:3DR Pixhawk Mini Autopilot Micro M8N GPS Built-in Compass PDB Board Main Processor:STM32F427 Rev 3IO Processor: STM32F103 Accel/ Gyro/ Mag: MPU9250 Accel/ Gyro: ICM20608 Barometer: MS5611 Power Module Output: 4.1-5.5 V Max Input Voltage: 45V (10S Li Po) Max Current Sensing: 90AUSB Power Input: 4.1-5.5 V Servo Rail Input: 0-10 V Dimensions: 38x 43x 12mm Weight: 15.8g Interfaces:- 1x UARTSerial Port (for GPS)- Spektrum DSM/DSM2/DSM-X Satellite Compatible R Cinput- Futaba SBUS Compatible R Cinput- PPMSum Signal RCInput- I2C (for digital sensors)- CAN (for digital motor control with compatible controllers)- ADC (for analog sensors)- Micro USB (Universal Serial Bus) Port GPS Module (Built-in Compass HMC5983):- Based on the M8N, - Concurrent reception of up to 3 GNSS (GPS, Galileo, GLONASS, Bei Dou)- Industry leading 167 d Bm navigation sensitivity- Security & integrity protection- Supports all satellite augmentation systems- Advanced jamming & spoofing detection- Product variants to meet performance & cost requirements
Size: 37x 37x 12mm Weight: 22.4g Pacakage Included:1x 3DR Pixhawk Mini 1x GPS Module 1x PDB Board 1x b
...

Holy Bro 433 Mhz 915 Mhz 100m W Transceiver Radio Telemetry Set V3 for PIXHawk 4 Flight Controller Introducation: It is a small, light & inexpensive open source radio platform that typically allows ranges of better than 300m out of the box (the range can be extended to several kilometers with the use of a patch antenna on the ground). The radio uses open source firmware which has been specially designed to work well with MAVLink packetsand to be integrated with the Mission Planner, Copter, Rover, & Plane. Specification: Brand Name: Holy Bro Version: 433 Mhz / 915 Mhz (Optional) Item Name:433 Mhz 915 Mhz 100m W Transceiver Radio Telemetry Set V3 Application: Compatible for Pixhawk 4 Flight Controller
Size: 26 x 53 x 10.7mm (without antenna) Processing- 100 m W maximum output power (adjustable) -117 d Bm receive sensitivity- Open-source SIK firmware- RP-SMA connector- 2-way full-duplex communication through adaptive TDM UART interface- Transparent serial link- MAVLink protocol framing- Frequency Hopping Spread Spectrum (FHSS) Configurable duty cycle- Error correction corrects up to 25% of bit errors Open-source SIK firmware Configurable through Mission Planner APM Planner FT230X is a USB (Universal Serial Bus) to BASIC UART ICPower- Supply Voltage: 5VDC (from USB (Universal Serial Bus) or JST-GH)- Transmit Current: 100 m A at 20d Bm- Receive current: 25 m A- Serial interface: 3.3 V UARTStatus LEDs- The radios have 2 status LEDs, one red & one green. The meaning of the different LED states is:- Green LED blinking
- searching for another radio-

...

Holybro 433 Mhz 915 Mhz 500m W Transceiver Radio Telemetry Set V3 for PIXHawk 4 Flight Controller Introducation: It is a small, light & inexpensive open source radio platform that typically allows ranges of better than 300m out of the box (the range can be extended to several kilometers with the use of a patch antenna on the ground). The radio uses open source firmware which has been specially designed to work well with MAVLink packetsand to be integrated with the Mission Planner, Copter, Rover, & Plane. Specification: (Manual) Brand Name: Holybro Version: 433 Mhz / 915 Mhz (Optional) Item Name: 500m W Transceiver Radio Telemetry Set V3 Application: Compatible for Pixhawk 4 Flight Controller
Size: 26 x 53 x 10.7mm (without antenna) Processing- 100 m W maximum output power (adjustable) -117 d Bm receive sensitivity- Open-source SIK firmware- RP-SMA connector- 2-way full-duplex communication through adaptive TDM UART interface- Transparent serial link- MAVLink protocol framing- Frequency Hopping Spread Spectrum (FHSS) Configurable duty cycle- Error correction corrects up to 25% of bit errors Open-source SIK firmware Configurable through Mission Planner APM Planner FT230X is a USB (Universal Serial Bus) to BASIC UART ICPower- Supply Voltage: 5VDC (from USB (Universal Serial Bus) or JST-GH)- Transmit Current: 500 m A at 27d Bm- Receive current: 25 m A- Serial interface: 3.3 V UARTStatus LEDs- The radios have 2 status LEDs, one red & one green. The meaning of the different LED states is:- Green LED blinking
- searching for another radio- Gree

...

Holybro Atlatl 5.8G 40CH 25m W 100m W mini FPV Video Transmitter 4.5-5.5V 19x 16mm for RC FPV Racing Drone Specification: Brand name: Holybro Item name: Atlatl Mini FPV Video Transmitter Output Power: 0.5 m W (pit mode), 25 m W, 100 m W Antenna Connector: MMCX Input Voltage: 4.5 to 5.5 volts (nominal 5v power) Dimensions: 19x 16x 4.5mm Weight: 1.6g (without antenna) Feature: Compatible with all major FPV receivers from vendors such as Fatshark, Immersion RC, etc. Supports the standard 40-channel set: band A, B, E, Fatshark, & Raceb&. TBS Telemetry Protocol input allows remote control by the flight controller. Change channel, transmit power, & more from Betaflight OSD, flight controller USB (Universal Serial Bus) port, Taranis Lua Script, & more. MMCX connector is durable & easy to use. Rated for 100s of mating cycles. Easy & quick antenna changes. No more ripped-off UFL connectors. Variable transmit power 25 m W or 100 m W. 0.5 m W True Pit Mode means that you can power up safely without the risk of knocking other pilots out of the air. Tiny form factor for easy installation in tight racing builds. Atlatl Mini VTX English Manual Package Included:1 x Atlatl Mini FPV Video Transmitter ...

Holybro Atlatl HV micro V1.0 5.8G 40CH 25/200/500/800m W Switchable VTX FPV Transmitter Specification: Brand Name: Holybro Model: Atlatl HV micro V1.0 Item Name:5.8G 40CH 25/200/500/800m W Switchable FPV Transmitter Output Power: 0.5 m W (pit mode), 25 m W, 200 m W, 500 m W, 800 m W Audio: 6.5 MHz Mono Antenna Connector: MMCXInput Voltage: 7 to 21 volts (2-4S Li Po) with absolute maximum 30 volts Dimensions: 30x 26x 7mm Mounting Holes: Standard 20mm square to center of holes Weight: 3.6g

Features:- Compatible with all major FPV receivers from vendors such as Fatshark, Immersion RC, etc.- Supports the standard 40-channel set: band A, B, E, Fatshark, & Raceb&.- Smart Audio input allows remote control by the flight controller. Change channel, transmit power, & more from Betaflight OSD, flight controller USB (Universal Serial Bus) port, Taranis Lua Script, & more.- All parameters are controllable via push-button on the side of the unit, for cases where Smart Audio is not used.- MMCX connector is durable & easy to use. Rated for 100s of mating cycles. Easy & quick antenna changes. No more ripped-off UFL connectors.- LED indicators for channel, b&, & power. Allows easy check of v TX parameters simply by glancing at the quad.- Variable transmit power from 25 m W to 800 m W. Use 25 m W for a race & then easily switch to 800 m W for freestyle.- 0.5 m W True Pit Mode means that you can power up safely without the risk of knocking other pilots out of the air.- Built in microphone, so you can listen to your motors while you fly

...

Holybro Cable Set for Holybro PIX32 V5 Pixhawk Flight Controller RC Drone Multirotor Specification: Brand name: Holybro Item name: Cable Set for Holybro PIX32 V5 Pixhawk Flight Controller Package Included:3 x 6 to 6 pin cable (power Telem)3 x 4 to 4 pin cable (CANI2C)1 x 8 to 8 pin cable (CAP)1 x 7 to 7 pin cable (SPI)1 x DSMX receiver cable 1 x PPM/SBUS out cable 1 x Debug cable 1 x USB (Universal Serial Bus) (type-c)cable ...

Holybro FUTABA Fasst Compatible Receiver for T8FG T14FG 12Z T18MZSpecification: Brand name: Holybro Operating Current: 50m A max Operating Voltage: 3.5V-9.5 V Latency: S.BUS mode:14m S @ FASST multi-channel mode, 16m S @ FASST 7ch mode Sensitivity: Approx -90d Bm Weight: Approx 2g Dimensions: 31*28mm Output mode: S.BUSNumber of channels: 14 Range: Approx 1km
Size:31*28mm Usage: FUTABA Fasst compatible receiver, the minitype receiver designed for FPV drone (T8FG, T14FG, 12Z, T18MZ) Package included:1 x Holybro Receiver
...

Only US$57.79, buy best holybro digital air speed sensor ms 5525dso supported on all holybro autopilot flight controller boards with ardupilot & px 4 sale online store at wholesale price. ...

Holybro Durandal (beta) Ardupilot Flight controller PM07 Power Module for RC FPV Racing Drone Durandal is the latest update to the successful family of Holybro flight controllers. It was designed & developed by Holybro, optimized to run the latest Ardupilot firmware. It features the latest advanced processor technology from STMicroelectronics, sensor technology from Bosch & Inven Sense, & a Chibi OS real-time operating system, delivering incredible performance, flexibility, & reliability for controlling any autonomous vehicle. Durandals STM32H7 microcontroller, running at 480 M Hz, has 2 MB of Flash memory & 1 MB of RAM. With the increased processor power & ample resources, developers can freely implement more complex algorithms & models on the autopilot. Dual high-performance, low-noise IMUs on board are designed for demanding stabilization applications. Data-ready signals from all sensors are routed to separate interrupt & timer capture pins on the autopilot, permitting precise time-stamping of sensor data. Newly designed vibration isolation enables more accurate readings, allowing vehicles to achieve better overall flight performance. The two external SPI buses & six associated chip select lines allow for additional sensors & an SPI-interfaced payload. There are a total of four I2C buses: two dedicated for external use & two grouped with serial ports for GPS/compass modules. The Durandal is the latest update to the successful family of Holybro flight controllers ...

Holybro Durandal (beta) Ardupilot Flight Controller PM07 Power Module UBLOX NEO-M8N GPS for RC Drone Durandal is the latest update to the successful family of Holybro flight controllers. It was designed & developed by Holybro, optimized to run the latest Ardupilot firmware. It features the latest advanced processor technology from STMicroelectronics, sensor technology from Bosch & Inven Sense, & a Chibi OS real-time operating system, delivering incredible performance, flexibility, & reliability for controlling any autonomous vehicle. Durandals STM32H7 microcontroller, running at 480 M Hz, has 2 MB of Flash memory & 1 MB of RAM. With the increased processor power & ample resources, developers can freely implement more complex algorithms & models on the autopilot. Dual high-performance, low-noise IMUs on board are designed for demanding stabilization applications. Data-ready signals from all sensors are routed to separate interrupt & timer capture pins on the autopilot, permitting precise time-stamping of sensor data. Newly designed vibration isolation enables more accurate readings, allowing vehicles to achieve better overall flight performance. The two external SPI buses & six associated chip select lines allow for additional sensors & an SPI-interfaced payload. There are a total of four I2C buses: two dedicated for external use & two grouped with serial ports for GPS/compass modules. The Durandal is the latest update to the successful family of Holybro flight cont ...