United Kingdom
France
Germany
Netherlands
Sweden
USA
Italy
Spain
More From Contributor
DasMikro Programmable Sound Unit For Orlandoo F150 OH35P01 KIT Micro
RC Crawlers
ProgrammableSound Unit for Orlandoo F150 OH35P01 KIT Micro RC CrawlersDescription:This soundunit is developed specially for electric powered RC.It could be used to 1:35, 1/24 and 1/18 RC crawlers. Especially suitable for Orlandoo F150 OH35P01 KIT Assemble Climbing RC Car Parts VersionFeatures:Plug and PlaySoundquality 22KHzInternal 1W amplifier at 8 Ohm speakersAll connections done by plugs, no solderwork necessaryReceiver signals are used for speed information, this allows brushless or DC Motor usageFully assembeled in SMD technology (no heavy, vibration sensitive components)All wires includedVery little dimensions and weightTechnical Datas:Dimensions: 11 x 23, 5 x 3, 2mm (min.11x16x3, 2mm)Voltage: 3V to 5V (supplied by the receiver) Note the maximum supply voltage of 5V!Current: app.
10mA without sound, app. 250mA at max. volumeSpeaker: 8-32 OhmOutput power: 1W at 8-Ohm at 5V; 0, 6W at 8-Ohm at 3VProportional inputs: Positive Impuls 0, 8ms bis 2, 0msSoundquality: up to 22, 05 kHzTeaching the sound unit for throttle idle/accelerate point:1. Power on transmitter and receiver. LED blinks fast - normal mode. Bring throttle stick to idle. Motor must not move.2. Bridge study switch for about 0.5 seconds until beep - LED cont. on.At this moment the idle position of the throttle stick is stored.3. Move throttle stick to your desired acceleration point (throttle stick position where idle dead band stops and engine running sound starts) and wait for a beep. Now the dead (neutral) band of th
10mA without sound, app. 250mA at max. volumeSpeaker: 8-32 OhmOutput power: 1W at 8-Ohm at 5V; 0, 6W at 8-Ohm at 3VProportional inputs: Positive Impuls 0, 8ms bis 2, 0msSoundquality: up to 22, 05 kHzTeaching the sound unit for throttle idle/accelerate point:1. Power on transmitter and receiver. LED blinks fast - normal mode. Bring throttle stick to idle. Motor must not move.2. Bridge study switch for about 0.5 seconds until beep - LED cont. on.At this moment the idle position of the throttle stick is stored.3. Move throttle stick to your desired acceleration point (throttle stick position where idle dead band stops and engine running sound starts) and wait for a beep. Now the dead (neutral) band of th
Product Description
Reviews/Comments
Add New
Vouchers
No voucher codes found.
Do you know a voucher code for this product or supplier? Add it to Insights for others to use.
Do you know a voucher code for this product or supplier? Add it to Insights for others to use.
Denmark